Roof Flashing Installation | Installing Roof Flashings, Roof Flashing Details, SBC Flashing Instructions

1765 OPA LOCKA BLVD
MIAMI, FL 33054

PHONE 800.228.2580

FAX 305.685.6360

ROOF FLASHING INSTALLATION

INSTALLATION GUIDE DOWNLOADS

Installation of roof flashing for pipes, conduit, and other round penetrations.

Slipover or snap together flashing unit. If two-piece roof flashing is used, field solder/seal vertical and horizontal seams watertight, then firmly embed flashing plate in bed of mastic.
Between the penetration and the flashing, insert backer rod 3/8” below top of sleeve flashing, apply sealant and tool for positive slope.
Install sealant cover around penetration and use bead of sealant at perimeter.

Installation of two-piece roof flashings for square tube, rectangle tube, angle irons, H Beams, I Beams, and channels.

Snap together flashing unit. Field solder/seal vertical and horizontal seams watertight, and firmly embed flashing plate in full bed of mastic.
Between the penetration and the flashing, insert backer rod 3/8” below top of sleeve flashing, apply sealant and tool for positive slope.
Install sealant cover around penetration and use bead of sealant at perimeter.

NOTE:

Prime and strip flash flange to roof per membrane manufacturer’s specifications.

1765 Opa Locka Blvd, Miami, FL 33054 | Toll Free: 800.228.2580 | Local: 305.685.6350